Network PhysicalLinkVisualizerMobileShowcase

Package: inet.showcases.visualizer.physicallinkactivity
File: showcases/visualizer/physicallinkactivity/PhysicallinkVisualizerShowcase.ned

TODO documentation

IntegratedVisualizer IPv4NetworkConfigurator Ieee80211ScalarRadioMedium AdhocHost AdhocHost AdhocHost AdhocHost AdhocHost AdhocHost AdhocHost

Usage diagram:

The following diagram shows usage relationships between types. Unresolved types are missing from the diagram.

Inheritance diagram:

The following diagram shows inheritance relationships for this type. Unresolved types are missing from the diagram.

Properties:

Name Value Description
isNetwork
display bgb=660,630

Unassigned submodule parameters:

Name Type Default value Description
configurator.minLinkWeight double 1E-3
configurator.config xml xml("")

XML configuration parameters for IP address assignment and adding manual routes
configurator.assignAddresses bool true

assign IP addresses to all interfaces in the network
configurator.assignDisjunctSubnetAddresses bool true

avoid using the same address prefix and netmask on different links when assigning IP addresses to interfaces
configurator.addStaticRoutes bool true

add static routes to the routing tables of all nodes to route to all destination interfaces (only where applicable; turn off when config file contains manual routes)
configurator.addDefaultRoutes bool true

add default routes if all routes from a source node go through the same gateway (used only if addStaticRoutes is true)
configurator.addSubnetRoutes bool true

add subnet routes instead of destination interface routes (only where applicable; used only if addStaticRoutes is true)
configurator.optimizeRoutes bool true

optimize routing tables by merging routes, the resulting routing table might route more packets than the original (used only if addStaticRoutes is true)
configurator.dumpTopology bool false

print extracted network topology to the module output
configurator.dumpLinks bool false

print recognized network links to the module output
configurator.dumpAddresses bool false

print assigned IP addresses for all interfaces to the module output
configurator.dumpRoutes bool false

print configured and optimized routing tables for all nodes to the module output
configurator.dumpConfig string ""

write configuration into the given config file that can be fed back to speed up subsequent runs (network configurations)
radioMedium.neighborCache.refillPeriod double
host1.status.initialStatus string "UP"

TODO @signal, @statistic
host1.routingTable.forwarding bool
host1.routingTable.multicastForwarding bool
host1.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
host1.pcapRecorder.verbose bool false

whether to log packets on the module output
host1.pcapRecorder.pcapFile string ""

the PCAP file to be written
host1.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
host1.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
host1.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
host1.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
host1.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
host1.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
host1.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
host1.lo0.lo.mtu int 4470B
host2.status.initialStatus string "UP"

TODO @signal, @statistic
host2.routingTable.forwarding bool
host2.routingTable.multicastForwarding bool
host2.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
host2.pcapRecorder.verbose bool false

whether to log packets on the module output
host2.pcapRecorder.pcapFile string ""

the PCAP file to be written
host2.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
host2.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
host2.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
host2.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
host2.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
host2.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
host2.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
host2.lo0.lo.mtu int 4470B
host3.status.initialStatus string "UP"

TODO @signal, @statistic
host3.routingTable.forwarding bool
host3.routingTable.multicastForwarding bool
host3.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
host3.pcapRecorder.verbose bool false

whether to log packets on the module output
host3.pcapRecorder.pcapFile string ""

the PCAP file to be written
host3.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
host3.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
host3.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
host3.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
host3.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
host3.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
host3.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
host3.lo0.lo.mtu int 4470B
host4.status.initialStatus string "UP"

TODO @signal, @statistic
host4.routingTable.forwarding bool
host4.routingTable.multicastForwarding bool
host4.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
host4.pcapRecorder.verbose bool false

whether to log packets on the module output
host4.pcapRecorder.pcapFile string ""

the PCAP file to be written
host4.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
host4.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
host4.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
host4.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
host4.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
host4.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
host4.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
host4.lo0.lo.mtu int 4470B
host5.status.initialStatus string "UP"

TODO @signal, @statistic
host5.routingTable.forwarding bool
host5.routingTable.multicastForwarding bool
host5.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
host5.pcapRecorder.verbose bool false

whether to log packets on the module output
host5.pcapRecorder.pcapFile string ""

the PCAP file to be written
host5.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
host5.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
host5.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
host5.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
host5.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
host5.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
host5.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
host5.lo0.lo.mtu int 4470B
host6.status.initialStatus string "UP"

TODO @signal, @statistic
host6.routingTable.forwarding bool
host6.routingTable.multicastForwarding bool
host6.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
host6.pcapRecorder.verbose bool false

whether to log packets on the module output
host6.pcapRecorder.pcapFile string ""

the PCAP file to be written
host6.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
host6.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
host6.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
host6.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
host6.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
host6.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
host6.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
host6.lo0.lo.mtu int 4470B
host7.status.initialStatus string "UP"

TODO @signal, @statistic
host7.routingTable.forwarding bool
host7.routingTable.multicastForwarding bool
host7.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
host7.pcapRecorder.verbose bool false

whether to log packets on the module output
host7.pcapRecorder.pcapFile string ""

the PCAP file to be written
host7.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
host7.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
host7.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
host7.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
host7.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
host7.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
host7.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
host7.lo0.lo.mtu int 4470B

Source code:

//
// TODO documentation
//
network PhysicalLinkVisualizerMobileShowcase
{
    @display("bgb=660,630");
    submodules:
        visualizer: IntegratedVisualizer {
            @display("p=100,50");
        }
        configurator: IPv4NetworkConfigurator {
            @display("p=100,150");
        }
        radioMedium: Ieee80211ScalarRadioMedium {
            @display("p=100,250");
        }
        host1: AdhocHost {
            @display("p=509.736,103.976");
        }
        host2: AdhocHost {
            @display("p=365.184,213.024");
        }
        host3: AdhocHost {
            @display("p=498.324,229.508");
        }
        host4: AdhocHost {
            @display("p=280.228,365.184");
        }
        host5: AdhocHost {
            @display("p=365.184,517.344");
        }
        host6: AdhocHost {
            @display("p=523.684,372.792");
        }
        host7: AdhocHost {
            @display("p=267.548,139.48");
        }
}

This documentation is released under the Creative Commons license