Network SimpleConfiguratorNetwork

Package: inet.examples.inet.configurator
File: examples/inet/configurator/SimpleConfiguratorNetwork.ned

(no description)

IPv4NetworkConfigurator StandardHost StandardHost StandardHost StandardHost

Usage diagram:

The following diagram shows usage relationships between types. Unresolved types are missing from the diagram.

Inheritance diagram:

The following diagram shows inheritance relationships for this type. Unresolved types are missing from the diagram.

Properties:

Name Value Description
isNetwork
display bgb=450,300

Unassigned submodule parameters:

Name Type Default value Description
configurator.minLinkWeight double 1E-3
configurator.config xml xml("")

XML configuration parameters for IP address assignment and adding manual routes

configurator.assignAddresses bool true

assign IP addresses to all interfaces in the network

configurator.assignDisjunctSubnetAddresses bool true

avoid using the same address prefix and netmask on different links when assigning IP addresses to interfaces

configurator.addStaticRoutes bool true

add static routes to the routing tables of all nodes to route to all destination interfaces (only where applicable; turn off when config file contains manual routes)

configurator.addDefaultRoutes bool true

add default routes if all routes from a source node go through the same gateway (used only if addStaticRoutes is true)

configurator.addSubnetRoutes bool true

add subnet routes instead of destination interface routes (only where applicable; used only if addStaticRoutes is true)

configurator.optimizeRoutes bool true

optimize routing tables by merging routes, the resulting routing table might route more packets than the original (used only if addStaticRoutes is true)

configurator.dumpTopology bool false

print extracted network topology to the module output

configurator.dumpLinks bool false

print recognized network links to the module output

configurator.dumpAddresses bool false

print assigned IP addresses for all interfaces to the module output

configurator.dumpRoutes bool false

print configured and optimized routing tables for all nodes to the module output

configurator.dumpConfig string ""

write configuration into the given config file that can be fed back to speed up subsequent runs (network configurations)

host11.status.initialStatus string "UP"

TODO @signal, @statistic

host11.routingTable.forwarding bool
host11.routingTable.multicastForwarding bool
host11.interfaceTable.displayAddresses bool false

whether to display IP addresses on links

host11.pcapRecorder.verbose bool false

whether to log packets on the module output

host11.pcapRecorder.pcapFile string ""

the PCAP file to be written

host11.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet

host11.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError

host11.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on

host11.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to

host11.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to

host11.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash

host11.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module

host11.lo0.lo.mtu int 4470B
host21.status.initialStatus string "UP"

TODO @signal, @statistic

host21.routingTable.forwarding bool
host21.routingTable.multicastForwarding bool
host21.interfaceTable.displayAddresses bool false

whether to display IP addresses on links

host21.pcapRecorder.verbose bool false

whether to log packets on the module output

host21.pcapRecorder.pcapFile string ""

the PCAP file to be written

host21.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet

host21.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError

host21.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on

host21.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to

host21.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to

host21.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash

host21.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module

host21.lo0.lo.mtu int 4470B
host12.status.initialStatus string "UP"

TODO @signal, @statistic

host12.routingTable.forwarding bool
host12.routingTable.multicastForwarding bool
host12.interfaceTable.displayAddresses bool false

whether to display IP addresses on links

host12.pcapRecorder.verbose bool false

whether to log packets on the module output

host12.pcapRecorder.pcapFile string ""

the PCAP file to be written

host12.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet

host12.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError

host12.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on

host12.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to

host12.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to

host12.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash

host12.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module

host12.lo0.lo.mtu int 4470B
host22.status.initialStatus string "UP"

TODO @signal, @statistic

host22.routingTable.forwarding bool
host22.routingTable.multicastForwarding bool
host22.interfaceTable.displayAddresses bool false

whether to display IP addresses on links

host22.pcapRecorder.verbose bool false

whether to log packets on the module output

host22.pcapRecorder.pcapFile string ""

the PCAP file to be written

host22.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet

host22.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError

host22.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on

host22.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to

host22.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to

host22.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash

host22.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module

host22.lo0.lo.mtu int 4470B

Source code:

network SimpleConfiguratorNetwork
{
    @display("bgb=450,300");
    submodules:
        configurator: IPv4NetworkConfigurator {
            parameters:
                @display("p=50,50");
        }
        host11: StandardHost {
            parameters:
                @display("p=200,50");
        }
        host21: StandardHost {
            parameters:
                @display("p=400,50");
        }
        host12: StandardHost {
            parameters:
                @display("p=200,250");
        }
        host22: StandardHost {
            parameters:
                @display("p=400,250");
        }
    connections allowunconnected:
        host11.ethg++ <--> Eth1G <--> host21.ethg++;
        host11.ethg++ <--> Eth1G <--> host12.ethg++;
        host21.ethg++ <--> Eth1G <--> host22.ethg++;
        host12.ethg++ <--> Eth1G <--> host22.ethg++;
}