Network WirelessNetWithDHCP

Package: inet.examples.dhcp
File: examples/dhcp/WirelessNetWithDHCP.ned

(no description)

Ieee80211ScalarRadioMedium Router WirelessHost AccessPoint StandardHost IPv4NetworkConfigurator StandardHost

Usage diagram:

The following diagram shows usage relationships between types. Unresolved types are missing from the diagram.

Inheritance diagram:

The following diagram shows inheritance relationships for this type. Unresolved types are missing from the diagram.

Parameters:

Name Type Default value Description
numHosts int

Properties:

Name Value Description
isNetwork
display bgb=590,407;bgl=2

Unassigned submodule parameters:

Name Type Default value Description
radioMedium.neighborCache.refillPeriod double
gateway.status.initialStatus string "UP"

TODO @signal, @statistic
gateway.routingTable.forwarding bool
gateway.routingTable.multicastForwarding bool
gateway.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
gateway.pcapRecorder.verbose bool false

whether to log packets on the module output
gateway.pcapRecorder.pcapFile string ""

the PCAP file to be written
gateway.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
gateway.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
gateway.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
gateway.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
gateway.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
gateway.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
gateway.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
gateway.lo0.lo.mtu int 4470B
gateway.bgp.interfaceTableModule string

The path to the InterfaceTable module
gateway.bgp.routingTableModule string
gateway.bgp.ospfRoutingModule string hasOSPF ? "^.ospf" : ""
gateway.bgp.dataTransferMode string
client.status.initialStatus string "UP"

TODO @signal, @statistic
client.routingTable.forwarding bool
client.routingTable.multicastForwarding bool
client.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
client.pcapRecorder.verbose bool false

whether to log packets on the module output
client.pcapRecorder.pcapFile string ""

the PCAP file to be written
client.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
client.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
client.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
client.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
client.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
client.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
client.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
client.lo0.lo.mtu int 4470B
ap.status.initialStatus string "UP"

TODO @signal, @statistic
ap.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
ap.macTable.agingTime double
ap.macTable.addressTableFile string
dhcpServer.status.initialStatus string "UP"

TODO @signal, @statistic
dhcpServer.routingTable.forwarding bool
dhcpServer.routingTable.multicastForwarding bool
dhcpServer.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
dhcpServer.pcapRecorder.verbose bool false

whether to log packets on the module output
dhcpServer.pcapRecorder.pcapFile string ""

the PCAP file to be written
dhcpServer.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
dhcpServer.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
dhcpServer.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
dhcpServer.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
dhcpServer.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
dhcpServer.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
dhcpServer.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
dhcpServer.lo0.lo.mtu int 4470B
configurator.minLinkWeight double 1E-3
configurator.config xml xml("")

XML configuration parameters for IP address assignment and adding manual routes
configurator.assignAddresses bool true

assign IP addresses to all interfaces in the network
configurator.assignDisjunctSubnetAddresses bool true

avoid using the same address prefix and netmask on different links when assigning IP addresses to interfaces
configurator.addStaticRoutes bool true

add static routes to the routing tables of all nodes to route to all destination interfaces (only where applicable; turn off when config file contains manual routes)
configurator.addDefaultRoutes bool true

add default routes if all routes from a source node go through the same gateway (used only if addStaticRoutes is true)
configurator.addSubnetRoutes bool true

add subnet routes instead of destination interface routes (only where applicable; used only if addStaticRoutes is true)
configurator.optimizeRoutes bool true

optimize routing tables by merging routes, the resulting routing table might route more packets than the original (used only if addStaticRoutes is true)
configurator.dumpTopology bool false

print extracted network topology to the module output
configurator.dumpLinks bool false

print recognized network links to the module output
configurator.dumpAddresses bool false

print assigned IP addresses for all interfaces to the module output
configurator.dumpRoutes bool false

print configured and optimized routing tables for all nodes to the module output
configurator.dumpConfig string ""

write configuration into the given config file that can be fed back to speed up subsequent runs (network configurations)
remote.status.initialStatus string "UP"

TODO @signal, @statistic
remote.routingTable.forwarding bool
remote.routingTable.multicastForwarding bool
remote.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
remote.pcapRecorder.verbose bool false

whether to log packets on the module output
remote.pcapRecorder.pcapFile string ""

the PCAP file to be written
remote.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
remote.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
remote.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on
remote.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
remote.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
remote.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
remote.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module
remote.lo0.lo.mtu int 4470B

Source code:

network WirelessNetWithDHCP
{
    @display("bgb=590,407;bgl=2");
    int numHosts;
    **.mgmt.numChannels = 5;
    submodules:
        radioMedium: Ieee80211ScalarRadioMedium {
            @display("p=64,34");
        }
        gateway: Router {
            @display("p=365,35");
        }
        client[numHosts]: WirelessHost {
            @display("r=,,#707070;p=245,285");
        }
        ap: AccessPoint {
            @display("p=126,98");
        }
        dhcpServer: StandardHost {
            @display("p=64,307");
        }
        configurator: IPv4NetworkConfigurator {
            parameters:
                @display("p=180,35");
        }
        remote: StandardHost {
            @display("p=540,204");
        }
    connections:
        gateway.ethg++ <--> Eth100M <--> ap.ethg++;
        gateway.ethg++ <--> Eth100M <--> remote.ethg++;
        dhcpServer.ethg++ <--> Eth100M <--> ap.ethg++;
}

This documentation is released under the Creative Commons license