Network QosThroughput

Package: inet.examples.adhoc.qos
File: examples/adhoc/qos/Qos.ned

(no description)

IPv4NetworkConfigurator AdhocHost AdhocHost Ieee80211ScalarRadioMedium

Usage diagram:

The following diagram shows usage relationships between types. Unresolved types are missing from the diagram.

Inheritance diagram:

The following diagram shows inheritance relationships for this type. Unresolved types are missing from the diagram.

Properties:

Name Value Description
isNetwork
display b=297,203

Unassigned submodule parameters:

Name Type Default value Description
configurator.minLinkWeight double 1E-3
configurator.config xml xml("")

XML configuration parameters for IP address assignment and adding manual routes

configurator.assignAddresses bool true

assign IP addresses to all interfaces in the network

configurator.assignDisjunctSubnetAddresses bool true

avoid using the same address prefix and netmask on different links when assigning IP addresses to interfaces

configurator.addStaticRoutes bool true

add static routes to the routing tables of all nodes to route to all destination interfaces (only where applicable; turn off when config file contains manual routes)

configurator.addDefaultRoutes bool true

add default routes if all routes from a source node go through the same gateway (used only if addStaticRoutes is true)

configurator.addSubnetRoutes bool true

add subnet routes instead of destination interface routes (only where applicable; used only if addStaticRoutes is true)

configurator.optimizeRoutes bool true

optimize routing tables by merging routes, the resulting routing table might route more packets than the original (used only if addStaticRoutes is true)

configurator.dumpTopology bool false

print extracted network topology to the module output

configurator.dumpLinks bool false

print recognized network links to the module output

configurator.dumpAddresses bool false

print assigned IP addresses for all interfaces to the module output

configurator.dumpRoutes bool false

print configured and optimized routing tables for all nodes to the module output

configurator.dumpConfig string ""

write configuration into the given config file that can be fed back to speed up subsequent runs (network configurations)

srvHost.status.initialStatus string "UP"

TODO @signal, @statistic

srvHost.routingTable.forwarding bool
srvHost.routingTable.multicastForwarding bool
srvHost.interfaceTable.displayAddresses bool false

whether to display IP addresses on links

srvHost.pcapRecorder.verbose bool false

whether to log packets on the module output

srvHost.pcapRecorder.pcapFile string ""

the PCAP file to be written

srvHost.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet

srvHost.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError

srvHost.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on

srvHost.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to

srvHost.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to

srvHost.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash

srvHost.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module

srvHost.lo0.lo.mtu int 4470B
cliHost.status.initialStatus string "UP"

TODO @signal, @statistic

cliHost.routingTable.forwarding bool
cliHost.routingTable.multicastForwarding bool
cliHost.interfaceTable.displayAddresses bool false

whether to display IP addresses on links

cliHost.pcapRecorder.verbose bool false

whether to log packets on the module output

cliHost.pcapRecorder.pcapFile string ""

the PCAP file to be written

cliHost.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet

cliHost.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError

cliHost.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*] ext[*]"

space-separated list of sibling module names to listen on

cliHost.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to

cliHost.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to

cliHost.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash

cliHost.lo0.lo.interfaceTableModule string

The path to the InterfaceTable module

cliHost.lo0.lo.mtu int 4470B
radioMedium.neighborCache.refillPeriod double

Source code:

network QosThroughput
{
    parameters:
        @display("b=297,203");
    submodules:
        configurator: IPv4NetworkConfigurator {
            @display("p=61,164");
        }
        srvHost: AdhocHost {
            parameters:
                @display("r=,,#707070");
        }
        cliHost: AdhocHost {
            parameters:
                @display("r=,,#707070");
        }
        radioMedium: Ieee80211ScalarRadioMedium {
            parameters:
                @display("p=61,46");
        }
}