Network MultiRadio

Package: inet.examples.manetrouting.multiradio
File: examples/manetrouting/multiradio/MultiRadio.ned

Models a network with several hosts. Each host may contain one or more radios. Nodes are using adhoc routing to pass information.

Usage diagram:

The following diagram shows usage relationships between types. Unresolved types are missing from the diagram.

Inheritance diagram:

The following diagram shows inheritance relationships for this type. Unresolved types are missing from the diagram.

Parameters:

Name	Type	Default value	Description
numHosts	int

Properties:

Name	Value	Description
isNetwork

Unassigned submodule parameters:

Name	Type	Default value	Description
radioMedium.neighborCache.refillPeriod	double
configurator.minLinkWeight	double	1E-3
configurator.assignAddresses	bool	true	assign IP addresses to all interfaces in the network
configurator.assignDisjunctSubnetAddresses	bool	true	avoid using the same address prefix and netmask on different links when assigning IP addresses to interfaces
configurator.optimizeRoutes	bool	true	optimize routing tables by merging routes, the resulting routing table might route more packets than the original (used only if addStaticRoutes is true)
configurator.dumpTopology	bool	false	print extracted network topology to the module output
configurator.dumpLinks	bool	false	print recognized network links to the module output
configurator.dumpAddresses	bool	false	print assigned IP addresses for all interfaces to the module output
configurator.dumpRoutes	bool	false	print configured and optimized routing tables for all nodes to the module output
configurator.dumpConfig	string	""	write configuration into the given config file that can be fed back to speed up subsequent runs (network configurations)
mobileHost.status.initialStatus	string	"UP"	TODO @signal, @statistic
mobileHost.routingTable.forwarding	bool
mobileHost.routingTable.multicastForwarding	bool
mobileHost.interfaceTable.displayAddresses	bool	false	whether to display IP addresses on links
mobileHost.pcapRecorder.verbose	bool	false	whether to log packets on the module output
mobileHost.pcapRecorder.pcapFile	string	""	the PCAP file to be written
mobileHost.pcapRecorder.snaplen	int	65535	maximum number of bytes to record per packet
mobileHost.pcapRecorder.dumpBadFrames	bool	true	enable dump of frames with hasBitError
mobileHost.pcapRecorder.moduleNamePatterns	string	"wlan[] eth[] ppp[] ext[]"	space-separated list of sibling module names to listen on
mobileHost.pcapRecorder.sendingSignalNames	string	"packetSentToLower"	space-separated list of outbound packet signals to subscribe to
mobileHost.pcapRecorder.receivingSignalNames	string	"packetReceivedFromLower"	space-separated list of inbound packet signals to subscribe to
mobileHost.pcapRecorder.alwaysFlush	bool	false	flush the pcapFile after each write to ensure that all packets are captured in case of a crash
mobileHost.lo0.lo.interfaceTableModule	string		The path to the InterfaceTable module
mobileHost.lo0.lo.mtu	int	4470B

Source code:

//
// Models a network with several hosts. Each host may contain one or
// more radios. Nodes are using adhoc routing to pass information.
//
network MultiRadio
{
    parameters:
        int numHosts;
    submodules:
        radioMedium: Ieee80211ScalarRadioMedium {
            @display("p=83,15");
        }
        configurator: IPv4NetworkConfigurator {
            config = xml("<config><interface hosts='*' address='10.0.0.x' netmask='255.255.255.0'/></config>");
            addStaticRoutes = false;
            addDefaultRoutes = false;
            addSubnetRoutes = false;
            @display("p=253,15");
        }
        mobileHost[numHosts]: DYMORouter {
            @display("p=100,100;r=,,#000040");
        }
    connections allowunconnected:
}